News
-
Customization: Can equipment be customized for my special materials or special workpieces such as pi
Waterjets can be customized for special materials and workpieces like pipes. Options include pump pressure up to 6,200 Bar, pipe diameters 20–800mm, multi-head systems, and full 5-axis cutting. Winwin offers customizable equipment, pumps, and parts with global after-sales support.Read more -
High-Pressure System Maintenance: What are common faults and how are they troubleshooted?
Common high-pressure faults include pressure loss, unstable pressure, leakage, and oil overheating. Causes are usually worn seals, faulty check valves, or a failed accumulator. Regular inspection and timely replacement prevent downtime. Winwin offers waterjet equipment, pumps, and parts, fully customizable, with global after-sales support.Read more -
What is the difference between 3-axis and 5-axis waterjets? How should I choose?
3-axis waterjets cut vertically, causing 2–3° taper and extra finishing. 5-axis waterjets add rotary axes with dynamic taper compensation, achieving near-zero taper, ±0.025mm accuracy, and bevel cutting up to ±68° in one setup. Choose 3-axis for flat plates; 5-axis for thick materials and complex 3D work. Winwin offers both, fully customizable, with global after-sales support.Read more -
What are the main components of daily operating costs?
Daily waterjet operating costs include abrasive (the largest, ~75% of total, $18–36/hr), wear parts ($5–22/hr), electricity ($10–15/hr), and water ($1.2k–2.5k/yr). Pump maintenance ranges from $3k/yr (direct‑drive) to $15k/yr (intensifier). Winwin offers custom‑tuned systems and global after‑sales support to keep these costs predictable.Read more -
What cutting precision can a waterjet achieve?
Waterjet precision is measured by positioning accuracy (±0.05mm/m), repeat positioning accuracy (±0.025mm), and cutting tolerance (±0.1mm). Natural taper (2–3°) is corrected by 5‑axis dynamic compensation, achieving near‑vertical edges and tolerances as low as ±0.025mm. Winwin offers 3‑axis and 5‑axis systems with full customisation and worldwide after‑sales support.Read more -
Which pump type is better: intensifier pump or direct-drive pump?
Choose intensifier pumps for high‑pressure stability, thick materials, and multiple cutting heads; choose direct‑drive pumps for energy savings, lower cost, thin materials, and single‑head use. Winwin offers both types with customisation.Read more
