English Translation of Title:
Hex-Head Screw 5/8‑11 x 1‑1/2 – Waterjet Cutting Equipment Accessory (ID: 95897294)

Description, Purpose, Features, and Maintenance:

This component is a medium‑length hex‑head screw with a nominal diameter of 5/8 inch, 11 threads per inch (UNC), and a length of 1‑1/2 inches. It is used in waterjet cutting systems for general fastening applications where moderate clamping force and vibration resistance are required.

Purpose:

• Secures lightweight brackets, sensor mounts, cable tray supports, and guard panels to the machine frame.

• Provides positive fastening for adjustable stops, limit switch brackets, and hose routing clamps.

• Serves as a general‑purpose fastener in non‑critical structural joints that experience low to moderate dynamic loads.

Features:

• Manufactured from medium‑carbon steel with a protective anti‑corrosion finish suitable for humid workshop environments.

• Precision‑rolled threads ensure consistent engagement and reliable torque retention.

• Standard hex head design allows easy installation and removal with common hand tools.

• Heat‑treated to provide adequate tensile strength for accessory‑level fastening duties.

Maintenance:

• Visually inspect threads for wear, burrs, or corrosion before each installation.

• Replace if threads show significant galling, stripping, or if the head corners are rounded.

• Clean threads with a wire brush or solvent to remove debris and old anti‑seize compounds.

• Apply a light film of anti‑seize lubricant (compatible with waterjet environments) upon reassembly to prevent thread galling.

• Torque to the recommended value using a calibrated wrench; avoid overtightening.